Home > News > Problems and Reasons in the Process of Bag Making with Plastic Zipper
Online Service
Todd

Mr. Todd

Leave a message
Contact Now

Problems and Reasons in the Process of Bag Making with Plastic Zipper

2019-04-10
Problems and Reasons in the Process of Plastic Zipper Bag Making Machine Bag:
1. Continuous cutting of bags
1. There is coke in the cut; 2. The temperature of the cutter is too low; 3. The silicone conveyor belt is too slippery and sticky, and the conveyor belt is worn out; 4. The pressure of the cutter is insufficient.
2. There are black spots or pockmarks on the bags.
1. Rubber rollers and aluminium rollers are not cleaned; 2. Underneath the front and rear water pressure plates are not cleaned; 3. The conveyor belt is not clean; 4. There is coke at the edge of the knife.
3. Plastic bags with leaks or holes
1. There is coke at the edge of the knife; 2. Water pressure plate is pressed well; 3. The speed is too fast; 4. Chain clamping and rib are too thick; 5. The discharging roll is crushed.
4. Different Sizes of Plastic Bags
1. The non-ferrous switch on the computer is not started; 2. Cots are not pressed accurately; 3. Feeding motor is not opened; 4. Feeding cots are not pressed tightly; 5. Conveyor belt is too loose; 6. Clearance oil wear of transmission gear; 7. Synchronized belt is too loose; 8. Conveyor belt does not match the operation of cutting.
Related Products List

Home

Product

Phone

About Us

Inquiry

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Send